User Tools

Site Tools


how-to:connect-to-blender

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
how-to:connect-to-blender [2016/12/09 17:21]
robo [Test serial communication between Blender and OpenRex]
how-to:connect-to-blender [2016/12/09 17:22] (current)
robo [Disable console output]
Line 12: Line 12:
 We will be using serial port to communicate between OpenRex and Blender. We will be using serial port to communicate between OpenRex and Blender.
  
-  - Boot up OpenRex to Linux and check IP address (run "​ifconfig"​ command)<​code>​root@ubuntu-imx6:​~#​ ifconfig+  - Boot up OpenRex to Linux and check IP address (run "​ifconfig"​ command)<​sxh bash>​root@ubuntu-imx6:​~#​ ifconfig
 eth0      Link encap:​Ethernet ​ HWaddr 00:​0d:​01:​50:​0d:​ce eth0      Link encap:​Ethernet ​ HWaddr 00:​0d:​01:​50:​0d:​ce
           inet addr:​10.0.0.44 ​ Bcast:​10.0.0.255 ​ Mask:​255.255.255.0           inet addr:​10.0.0.44 ​ Bcast:​10.0.0.255 ​ Mask:​255.255.255.0
Line 21: Line 21:
           TX packets:17 errors:0 dropped:0 overruns:0 carrier:0           TX packets:17 errors:0 dropped:0 overruns:0 carrier:0
           collisions:​0 txqueuelen:​1000           collisions:​0 txqueuelen:​1000
-          RX bytes:2621 (2.6 KB)  TX bytes:2830 (2.8 KB)</code>+          RX bytes:2621 (2.6 KB)  TX bytes:2830 (2.8 KB)</sxh>
   - Use "​reboot"​ command to go into uBoot   - Use "​reboot"​ command to go into uBoot
   - Once you are in uBoot, remove console information from Kernel command line. Depends what you are using, SD card or SATA drive, try "​printenv"​ and look for "​mmcargs"​ or "​sataargs"​. It may look like this: <​code>​mmcargs=setenv bootargs console=${console},​${baudrate} root=${mmcroot} ${video_args} ip=dhcp   - Once you are in uBoot, remove console information from Kernel command line. Depends what you are using, SD card or SATA drive, try "​printenv"​ and look for "​mmcargs"​ or "​sataargs"​. It may look like this: <​code>​mmcargs=setenv bootargs console=${console},​${baudrate} root=${mmcroot} ${video_args} ip=dhcp
how-to/connect-to-blender.txt ยท Last modified: 2016/12/09 17:22 by robo